WITCOAT H.R.250°C ALUMINIUM PAINT / WITCOAT H.R.600°C ALUMINIUM PAINT

STORAGE

APPLICATION DETAILS

Mixing ratio: Airless spray/brush
Thinner: Do not dilute
Flim thickness (dry): 20-25 microns (by dft meter)

SURFACE PREPARATION

Remove oil grease with suitable detergent solution and other contaminants by high pressure fresh water hosing. Dust off the residue.

APPLICATION CONDITIONS

Apply only on a dry and clean surface, with a temperature above the dew point to avoid condensation.

SAFETY

As a general rule, inhalation of solvent vapour or paint mist and eye and skin contact with the liquid paint should be avoided. Forced ventilation should be provided when working with solvent borne coatings in confined spaces or stagnant air. Even when ventilation is provided, respiratory, skin, and eye protection are always recommended when spraying. In addition, national and local safety regulations should be followed.

TECHNICAL SPECIFICATION

PROPERTIES	SPECIFICATION	NOTE
Finish	Egg Shell
Application Viscosity @ 30°C	12-17 Sec	By B-4 Ford Cup
Shade	Aluminum
Volume Solid %	30%
Theoretical Spreading	12-15	M2/Ltr@ 35-45 Microns Dft
Flash Point	Above 25°C	Abel Closed Cup
Stoving Dried	600°C for 30 minutes	At 30°c
Shelf Life	6 months	At 30°c

DISCLAIMER

The information contained within this data sheet is based on information believed to be reliable at the time of its preparation. The company will not be liable for any loss or damage caused, including liability for negligence, that may be suffered by the user of the data contained herein. It is the user’s responsibility to conduct all necessary tests to confirm the suitability of any product or system for their intended use. Please be advised that no warranties are expressed or implied due to the inherent variability in product use, which is beyond our direct control.