Witcoat Q.D. Anticorrosive Paint is a modified alkyd based coatings resistant to Salt water, acids, alkalis and wide range of chemicals. This is free from Lead, Chromate, and Chlorine & Heavy metals.

As a finishing coat for exterior and interior surface, modified alkyd & Pigment based systems is used for corrosive marine and industrial environment. Suitable for protection of Pipes & structural steel in chemical and fertilizer plants, dock installation, thermal power plants etc.

  Finish   Smooth & Semi Glossy To Glossy   
  Application Viscosity @ 30°C   25-35 Sec   By B-4 Ford Cup
  Shade   According to the requirement of the party   Visually
  Volume Solid %   32 %   
  Theoretical Spreading   9-10   M2/Ltr @ 30-35 Microns Dry Film Thickness
  Flash Point   Above 25°C   Abel  Closed Cup
  Drying Time @ 30°C Tack Free Hard Dry    15-20 Minutes. 2-3 Hrs.   Excellent
  Shelf Life   6  Months   Months at 30°C

Application Method :Air Spray /Brush Recommended Thinner :Witcoat Q.D. Thinner Film Thickness :Dry: 35-45 microns (By Dft-Meter)

Remove oil grease with suitable detergent solution and other contaminants by high pressure fresh water hosing. Dust off the residue.

Apply only on a dry and clean surface, with a temperature above the dew point to avoid condensation.

As a general rule, inhalation of solvent vapour or paint mist and contact of liquid paint with skin and eyes should be avoided. Forced ventilation should be provided when working with solvent borne coating in confined spaces or stagnant air. Even when ventilation is provided respiratory skin & eyes protection are always recommended when spraying. In addition, national local safety regulations should be followed.

DISCLAIMER: The information contained within this data sheet is based on information believed to be reliable at the time of its preparation. The company will not be liable for loss or damage howsoever caused including liability for negligence, which may be suffered by the user of the data contained herein. It is the user's responsibility to conduct all necessary tests to confirm the suitability of any product or system for their intended use. No guarantee of results is implied since condition of use is beyond our control.